Lenovo ThinkServer TD200x Manual de usuario descargar pdf (Pagina 125)

v Change the position of the power-on password switch (enable switch 2 of the

system board switch block (SW6)) to bypass the power-on password check (see

the following illustration).

1 UEFI boot recovery jumper (JP6)

2 Clear CMOS jumper (JP1)

3 SW6 switch block

Attention: Before you change any switch settings or moving any jumpers, turn

off the server; then, disconnect all power cords and external cables. See the

safety information that begins on page vii. Do not change settings or move

jumpers on any system-board switch or jumper blocks that are not shown in this

document.

While the server is turned off, move switch 2 of the switch block (SW6) to the On

position to enable the power-on password override. You can then start the Setup

Utility and reset the power-on password. You do not have to return the switch to

the previous position.

The power-on password override jumper does not affect the administrator

password.

Administrator password

An administrator password is intended to be used by a system administrator; it

limits access to the full Setup Utility menu. If an administrator password is set, you

must type the administrator password for access to the full Setup Utility menu. You

can use any combination of up to seven characters (A - Z,a-z,and0-9)forthe

password.

Attention: If you set an administrator password and then forget it, there is no way

to change, override, or remove it. You must replace the system board.

Chapter 6. Configuring the server 109

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 213 214

Sin comentarios

Lenovo ThinkServer TD200x Manual de usuario Pagina 125