Lenovo ThinkServer RD120 Manual de usuario descargar pdf (Pagina 41)

1 Access holes 3 Release tabs

2 Guide 4 Guide

7. Connect any required cables to the adapter.

Attention:

v When you route cables, do not block any connectors or the ventilated space

around any of the fans.

v Make sure that cables are not routed on top of components under the PCI

riser-card assembly.

v Make sure that cables are not pinched by the server components.

Perform any configuration tasks that are required for the adapter.

If you have other optional devices to install, do so now. Otherwise, go to

“Completing the installation” on page 29.

Replacing the SAS controller

A SAS controller can be installed only in a dedicated slot on the system board. The

server comes with a ServeRAID-8k-l SAS Controller installed.

Note: The ServeRAID-8k-l SAS Controller does not have a battery.

To replace the ServeRAID-8k-l SAS Controller with a ServeRAID-8k SAS Controller,

complete the following steps:

1. Read the safety information that begins on page v and the “Installation

guidelines” on page 7.

2. Turn off the server and peripheral devices and disconnect all power cords and

external cables (see “Turning off the server” on page 37).

Chapter 2. Installing optional devices 27

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 99 100

Sin comentarios

Lenovo ThinkServer RD120 Manual de usuario Pagina 41