Lenovo ThinkServer TD100x Manual de usuario descargar pdf (Pagina 67)

10. If you are installing the ServeRAID-8k adapter into a simple-swap SATA model,

make the following cabling changes to enable RAID level-5 support:

a. Disconnect the signal cable from the Simple-swap SATA backplate

connector on the system board and connect it to the Hot-swap SAS/SATA

1 connector on the system board. See “System-board internal connectors”

on page 16 for the location of these connectors on the system board.

Note:

Remove the dust shield 1 (if one is present) from the Hot-swap

SAS/SATA 1 signal connector 2on the system board before installing the

signal cable. Carefully grasp the dust shield and pull it out of the signal

connector.

b. Connect the RAID level-5 enabler plug (that came with the system)1 to

the SAS/SATA backplane 1 connector on the system board.

Chapter 2. Installing optional devices 53

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 97 98

Sin comentarios

Lenovo ThinkServer TD100x Manual de usuario Pagina 67