Lenovo TD100 Manual de usuario descargar pdf (Pagina 99)

Removing an adapter

To remove an adapter, complete the following steps.

1. Read the safety information that begins on page vii and “Installation guidelines”

on page 73.

2. Turn off the server and all attached devices; then, disconnect all power cords

and external cables.

3. Unlock and remove the side cover (see “Removing the side cover” on page 78).

4. Disconnect any cables to the adapter or any cables that impede access to the

adapter.

5. Open the rear adapter-retention bracket retention clip and rotate the retention

brackets to the open (unlocked) position. If you are removing a full-length

adapter, open the front adapter-retention bracket also.

6. Remove the expansion-slot screw at the rear of the adapter (if screws were

used).

7. Carefully grasp the adapter by its top edge or upper corners, and pull the

adapter from the server.

Attention: Expansion-slot covers must be installed in all empty slots. This

maintains the electronic emissions standards of the computer and ensures

proper ventilation of computer components.

1 Retention clip 3 Adapter

2 Front adapter retention bracket 4 Rear adapter retention bracket

8. If the adapter is not being replaced, install an expansion-slot cover in the

expansion-slot opening.

9. If you are instructed to return the adapter, follow all packaging instructions, and

use any packaging materials for shipping that are supplied to you.

Chapter 4. Removing and replacing server components 81

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 253 254

Sin comentarios

Lenovo TD100 Manual de usuario Pagina 99