Lenovo RD210 Manual de usuario Pagina 104
- Pagina / 204
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
5. Disconnect the power cable from the power backplane.
6. Disconnect the signal cable from the system board.
7. Lift up to remove the backplane from the slots.
8. Push backwards on the backplane until it is clear of the slots.
9. Lift the backplane out of the server.
10. Disconnect the power cable and the signal cable from the disk drive
backplane.
1 Backplane tabs
2 Hard disk drive backplane
3 Backplane tabs
4 Backplane bracket slots
11. If you are instructed to return the backplane, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Installing the hot-swap SAS/SATA hard disk drive backplane
To install the replacement hot-swap SAS/SATA hard disk drive backplane, complete
the following steps:
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Connect the power cable and signal cable to the replacement backplane.
3. Insert the backplane into the drive cage.
4. Align the tabs on the backplane with the slots on the left and right brackets.
5. Push down firmly until the backplane is fully seated and the locking tabs snaps
into place.
6. Reconnect the power cable and the signal cable from the disk drive backplane.
88 ThinkServer RD210 Types 3795, 3796, 3818, and 3819: Installation and User Guide
- Installation and User Guide 1
- and User Gui de 3
- Contents 5
- Contents v 7
- Safety ix 11
- Safety xi 13
- Safety xiii 15
- Chapter 1. Introduction 17
- Related documentation 18
- Chapter 1. Introduction 3 19
- Features and technologies 23
- Specifications 26
- Software 28
- EasyStartup 28
- EasyManage 28
- Front view 31
- Operator information panel 32
- EasyLED diagnostics panel 33
- Rear view 41
- 4 Video connector 44
- System-board LEDs 49
- Power-supply LEDs 50
- System pulse LEDs 50
- Server power features 51
- Turning on the server 51
- Turning off the server 52
- Installation guidelines 55
- Removing the cover 59
- Replacing the cover 60
- 1 ServeRAID 61
- 2 SAS signal cables 61
- 2 Operator panel cable 62
- 2 Cable retention tab 63
- 3 Video cable 63
- 4 USB cable 63
- 1 Drive-tray assembly 67
- 2 Drive handle 67
- Removing an adapter 72
- Installing an adapter 73
- 1 Adapter 74
- 2 Expansion slot cover 74
- DIMM installation sequence 76
- Memory mirroring 76
- Installation steps 79
- Controller 80
- 1 SAS/SATA riser card 81
- 3 Riser card error LED 82
- 2 Microprocessor 87
- 3 Retainer bracket 87
- 4 Lock tab 87
- 3 Alignment marks 90
- Thermal grease 91
- Removing the battery 99
- Installing the battery 100
- 4 PCI riser connector 2 102
- 1 Backplane tabs 104
- 3 Backplane tabs 104
- Removing the system board 107
- Removing a CD/DVD drive 110
- Installing a CD/DVD drive 111
- Statement 3: 112
- Removing a CD/DVD cable 113
- 1 Cable connector latch 115
- 2 CD/DVD drive cable 115
- 3 Mounting tab 116
- 1 Ethernet adapter 118
- 3 Adapter bracket 118
- 2 Ethernet adapter 119
- 3 Battery 121
- 4 Release tab 121
- 1 Battery cable 122
- 4 Battery carrier 122
- 5 Battery connector 122
- Removing the bezel 124
- Installing the bezel 124
- Connecting the cables 127
- Using the Setup Utility 132
- Passwords 135
- Power-on password 136
- Administrator password 137
- Using the WebBIOS utility 141
- Using the EasyStartup DVD 143
- Setup and configuration 144
- Updating the firmware 146
- Installation requirements 150
- Installation order 151
- Diagnostic tools 157
- Error logs 158
- Clearing the error logs 159
- Troubleshooting tables 160
- EasyStartup problems 160
- CD/DVD drive problems 161
- General problems 161
- Hard disk drive problems 162
- Intermittent problems 162
- Memory problems 165
- Microprocessor problems 166
- Monitor problems 167
- Optional-device problems 169
- Power problems 170
- Serial-device problems 172
- Software problems 172
- Video problems 173
- EasyLED 173
- Remind button 174
- EasyLED switch 174
- EasyLED LEDs 175
- Power-supply diagnostics 179
- 1 AC LED (green) 180
- 2 DC LED (green) 180
- Before you call 183
- Using the documentation 183
- Calling for service 184
- Using other services 184
- Lenovo product service 185
- Appendix B. Notices 187
- Trademarks 188
- Important notes 188
- Hazardous Substances 189
- Battery return program 190
- Appendix B. Notices 175 191
- Appendix B. Notices 177 193
- Appendix B. Notices 179 195
- Index 183 199
- Index 185 201
- Part Number: 46U1926 204
- Printed in USA 204
- (1P) P/N: 46U1926 204
Relacionado con productos y manuales para Ordenadores Lenovo RD210
Ordenadores Lenovo 3000 Manual de usuario
(26 paginas)
(26 paginas)
Ordenadores Lenovo 5393 Manual de usuario
(94 paginas)
(94 paginas)
Ordenadores Lenovo 6446 Manual de usuario
(112 paginas)
(112 paginas)
Ordenadores Lenovo 3000 J Manual de usuario
(90 paginas)
(90 paginas)
Ordenadores Lenovo 4155 Manual de usuario
(76 paginas)
(76 paginas)
Ordenadores Lenovo 5248 Manual de usuario
(98 paginas)
(98 paginas)
Ordenadores Lenovo 1047 Manual de usuario
(140 paginas)
(140 paginas)
Ordenadores Lenovo H430 Desktop Manual de usuario
(66 paginas)
(66 paginas)
(9 paginas)
Ordenadores Lenovo H420 Desktop Manual de usuario
(39 paginas)
(39 paginas)
Ordenadores Lenovo C455 All-in-One Manual de usuario
(55 paginas)
(55 paginas)
Ordenadores Lenovo H420 Desktop Manual de usuario
(20 paginas)
(20 paginas)
Ordenadores Lenovo ThinkVantage Rescue and Recovery 4.3 (Deployment G Manual de usuario
(96 paginas)
(96 paginas)
Ordenadores Lenovo H50-00 Desktop Manual de usuario
(63 paginas)
(63 paginas)
Ordenadores Lenovo C225 All-In-One Manual de usuario
(61 paginas)
(61 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.064 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales