Lenovo RD210 Manual de usuario descargar pdf (Pagina 176)

Table 13. EasyLED panel LEDs (continued)

LED Description Action

OVER SPEC

(Continued)

The power supplies are

using more power than

their maximum rating.

If the 12V channel C error LED is lit, complete

the following steps:

1. Turn the server off and disconnect the

power from the server.

2. Remove the SAS/SATA RAID riser card,

DIMMs in connectors 1 through 8, and the

microprocessor in socket 1.

Note: The server will not power-on when

the microprocessor in socket 1 is not

installed in the server. You will need to

toggle the switch block (SW3) to pin 6 to

power-on the server.

3. Restart the server to see if the problem

remains.

4. Reinstall each device that was removed in

step b one at a time, starting the server

each time, to isolate the failing device.

5. Replace any failing device.

6. (Trained service technician only) Replace

the system board, if the problem remains.

the 12V channel D error LED is lit, complete

the following steps:

1. Turn the server off and disconnect the

power from the server.

2. Remove the microprocessor in socket 1.

Note: The server will not power-on when

the microprocessor in socket 1 is not

installed in the server. You will need to

toggle the switch block (SW3) to pin 6 to

power-on the server.

3. Restart the server to see if the problem

remains.

4. Reinstall the microprocessor in socket 1 and

restart the server.

5. Replace any failing device.

6. (Trained service technician only) Replace

the system board, if the problem remains.

(Continued

on the next page.)

160 ThinkServer RD210 Types 3795, 3796, 3818, and 3819: Installation and User Guide

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 203 204

Comentarios a estos manuales

Sin comentarios

Lenovo RD210 Manual de usuario Pagina 176

Comentarios a estos manuales

Relacionado con productos y manuales para Ordenadores Lenovo RD210