Lenovo Secure Managed Client Manual de usuario descargar pdf (Pagina 25)

Removing and installing a drive carrier module

To remove and install a drive carrier module, do the following:

CAUTION:

Observe all conventional ESD precautions when handling modules and

components. Avoid contact with backplane components and module connectors.

Removing a drive carrier module

To remove a drive carrier module, do the following:

Attention: Drive spin down - Damage can occur to a drive if it is removed while

still spinning. If possible, use the operating system to spin down a drive prior to

its removal. If not possible, perform all steps of the following procedure to ensure

that the drive has stopped spinning prior to removal.

Important:

Dummy drive carrier modules must be installed in all unused drive

bays. There will be inadequate drive cooling if any dummy modules are not

installed.:

1. Observe all safety and ESD precautions in the Safety and Warranty Guide.

2. See “De-activating an anti-tamper lock” on page 21 for instructions on

de-activating the lock if the lock as been activated

3. Release the carrier handle by pressing the latch in the handle towards the

handle hinge.

Figure 14. Re-installing enclosure cover

Chapter 3. Hardware installations and upgrades 17

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 51 52

Sin comentarios

Lenovo Secure Managed Client Manual de usuario Pagina 25