Lenovo Secure Managed Client Manual de usuario descargar pdf (Pagina 30)

4. If replacing the hard disk drive, see “Installing a hard disk drive into a drive

carrier” for instructions on installing a hard disk drive into a drive carrier. If

not replacing the hard disk drive, ensure that a blank drive carrier is installed

in the drive bay.

5. For instructions on re-installing the drive carrier into the drive bay, see

“Installing a drive carrier module” on page 19.

Installing a hard disk drive into a drive carrier

To install a hard disk drive into a drive carrier, do the following:

1. Observe all safety and ESD precautions in the Safety and Warranty Guide.

2. See “Removing a drive carrier module” on page 17 for instructions on

removing a drive carrier from a drive bay.

3. If replacing a hard disk drive, see “Removing a hard disk drive from a drive

carrier” on page 21 for instructions on removing a hard disk drive from a drive

carrier.

4. If not previously removed, remove the label from the inside of the drive carrier

by pulling up on the blue tab (see 1 in the following figure). Insert the hard

disk drive into the drive carrier, ensuring that the top of the hard disk drive

faces up and the connector end of the hard disk drive faces the rear of the

drive carrier. Secure the hard disk drive to the drive carrier with four screws

(see 2). Set any jumpers for the hard disk drive.

Figure 23. Removing hard disk drive from drive carrier

22 Secure Managed Client (SMC) - Storage Array Hardware Installation and Replacement Guide

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 51 52

Sin comentarios

Lenovo Secure Managed Client Manual de usuario Pagina 30