Lenovo Secure Managed Client Manual de usuario descargar pdf (Pagina 29)

Note: Do not turn the lock more than half a turn; otherwise, the drive carrier

may be damaged.

3. Remove the screwdriver.

De-activating an anti-tamper lock

To deactivate an anti-tamper lock, do the following:

1. Carefully insert the TORX* screwdriver provided into the cutout in the handle

(see 1 in the following figure).

2. Turn the screwdriver in a counter-clockwise direction until the lock symbol is

no longer visible in the opening beside the key (see 2).

Note:

Do not turn the lock more than half a turn; otherwise, the drive carrier

may be damaged.

3. Remove the screwdriver.

Removing and installing a hard disk drive into a drive carrier

To remove and install a hard disk drive into a drive carrier, do the following:

Removing a hard disk drive from a drive carrier

To remove a hard disk drive from a drive carrier, do the following:

1. Observe all safety and ESD precautions in the Safety and Warranty Guide.

2. See “Removing a drive carrier module” on page 17 for instructions on

removing a drive carrier from a drive bay.

3. Remove the four screws securing the hard disk drive to the drive carrier (see

1 in the following figure). Lift the hard disk drive out of the drive carrier.

Figure 21. Activating an anti-tamper lock

Figure 22. Deactivating an anti-tamper lock

Chapter 3. Hardware installations and upgrades 21

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 51 52

Sin comentarios

Lenovo Secure Managed Client Manual de usuario Pagina 29