Lenovo THINKSERVER RD230 Manual de usuario descargar pdf (Pagina 110)

Starting the Setup Utility program

To start the Setup Utility program, do the following:

1. Approximately three minutes after the server is connected to a working

electrical outlet, the power button becomes active. Turn on the server and the

POST runs automatically. You will then see the logo screen. The POST is a set

of tests and procedures that are performed each time you turn on your server.

2. Press Del as soon as you see the logo screen. The Setup Utility program opens.

If you have set an administrator password, you must type the administrator

password to access the full Setup Utility program menu. If you do not type the

correct administrator password, a limited Setup Utility program menu is

available.

Note: You can also press TAB as soon as you see the logo screen to review the

POST process and information.

3. The Setup Utility program menu lists various items about the system

configuration settings. Select the settings to view or change.

When working with the Setup Utility program, you must use the keyboard. The

keys used to perform various tasks are displayed at the bottom of each screen.

Note: Use the default setting for any item you are not familiar with. Do not

change the value of unfamiliar items or items that are not mentioned in this

manual to avoid any unexpected problems. If you cannot turn on the server

because of incorrect BIOS settings, refer to Table 7 on page 34 and use the

jumpers to clear CMOS and recover to the factory default settings.

Introduction of the BIOS items

The following tables list all the main menus and items in the Setup Utility

program. Some items might vary because of the BIOS updates.

Notes:

1. Use the default setting for any item you are not familiar with. Do not change

the value of unfamiliar items or items that are not mentioned in this manual to

avoid any unexpected problems. If you cannot turn on the server because of

incorrect BIOS settings, refer to Table 7 on page 34 and use the jumpers to clear

CMOS and recover to the factory default settings.

2. After updating the BIOS, all the BIOS settings become the default settings of

the updated BIOS version. You need to check and reconfigure the BIOS settings

for your specific needs.

Table 19. The Setup Utility program main menu

Item Description

Main Set the basic BIOS parameters.

Advanced Set the advanced BIOS parameters.

PCIPnP Set the PCI parameters.

Boot Set the boot parameters.

Security Set the security parameters.

Chipset Set the chipset.

Exit Exit the Setup Utility program.

104 ThinkServer RD230 Types 1043, 1044, 4010, and 4011: Hardware Maintenance Manual

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 147 148

Comentarios a estos manuales

Sin comentarios

Lenovo THINKSERVER RD230 Manual de usuario Pagina 110

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores Lenovo THINKSERVER RD230