
1. Remove all media from the drives and turn off all attached devices and the
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 42.
3. Remove the riser card. See “Removing the riser card” on page 57.
4. Install the PCI card into the slot on the riser card.
5. Install the riser card into an appropriate PCI card slot on the system board. See
“Installing the riser card” on page 56.
6. Connect any cables to the PCI card.
7. To complete the installation, go to “Completing the parts replacement” on page
87.
Removing a PCI card
Attention
Do not open your server or attempt any repair before reading and understanding the Safety
Information and the Warranty and Support Information on the ThinkServer Documentation DVD
that comes with your product, and “Guidelines” on page 37. To obtain a copy of the
publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to remove a PCI card.
The PCI card is installed on the riser card. To remove a PCI card, do the following:
Note: Use any documentation that comes with the PCI card and follow those
instructions in addition to the instructions in this section.
1. Remove all media from the drives and turn off all attached devices and the
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 42.
3. Disconnect any cables from the PCI card or any cables that impede access to
the riser card.
4. Remove the riser card together with the installed PCI card. See “Removing the
riser card” on page 57.
Figure 24. Installing a PCI card into the slot on the riser card
60 ThinkServer RD230 Types 1043, 1044, 4010, and 4011: Hardware Maintenance Manual
Comentarios a estos manuales