Lenovo THINKSERVER RD230 Manual de usuario Pagina 74

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 148
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 73
e. Carefully press the battery card assembly onto the RAID controller so that
the two connectors are firmly joined. Then, secure the battery card assembly
to the RAID controller with the three screws and the standoffs that come
with the battery card assembly accessory kit.
5. See “Installing a PCI card” on page 59 and follow those instructions to install
the RAID controller.
6. Connect the mini SAS signal cable to the RAID controller and the backplane by
doing the following:
Note: Use the 200 mm (7.87 inches) mini SAS signal cable.
1 Port 0-3 on the RAID
controller
3 Label for the mini SAS signal cable
2 SAS connector 4 SAS connector
a. Connect one end 2 of the mini SAS signal cable to the port 0-3 on the
RAID controller.
b. Connect the other end 4 of the mini SAS signal cable to the mini SAS
signal connector on the backplane. See “Locating connectors on the
backplane” on page 35.
7. To complete the installation, go to “Completing the parts replacement” on page
87.
Figure 30. Installing the battery card assembly
Figure 31. Connecting the mini SAS signal cable
68 ThinkServer RD230 Types 1043, 1044, 4010, and 4011: Hardware Maintenance Manual
Vista de pagina 73
1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 147 148

Comentarios a estos manuales

Sin comentarios