Lenovo ThinkServer TD100x Manual de usuario descargar pdf (Pagina 29)

Removing the bezel

Important: Before you install optional hardware, make sure that the server is

working correctly. Start the server, and make sure that the operating system starts,

if an operating system is installed, or that a 19990305 error code is displayed,

indicating that an operating system was not found but the server is otherwise

working correctly. If the server is not working correctly, see the Hardware

Maintenance Manual for diagnostic information.

To remove the bezel, complete the following steps:

1. Read the safety information that begins on page vii and “Installation guidelines”

on page 9.

2. Unlock the side cover.

Note: You must unlock the side cover to remove the bezel.

3. Position your finger on the depressed area on the left side of the bezel and

rotate the bezel away from the server.

4. Press the retention tabs 1 on the hinge assembly toward each other and pull

the hinge assembly out of the chassis.

Chapter 2. Installing options 13

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 123 124

Sin comentarios

Lenovo ThinkServer TD100x Manual de usuario Pagina 29