Lenovo ThinkServer TD100x Manual de usuario descargar pdf (Pagina 45)

d. Push the drive tray handle to the closed (locked) position.

e. Check the hard disk drive status indicator to make sure that the hard disk

drive is operating correctly. (You might have to restart the server before the

drive is recognized.) If the amber hard disk drive status LED for a drive is lit

continuously, it indicates that the drive is faulty and must be replaced. If the

amber hard disk drive status LED for a drive is flashing slowly, this indicates

that the drive is being rebuilt. If the amber hard disk drive status LED for a

drive is flashing rapidly, this indicates that the controller is identifying the

drive. If the green hard disk drive activity LED is flashing, it indicates that

the drive is in use.

Note: If the server is configured for RAID operation using an optional

ServeRAID

™

adapter, you might have to reconfigure your disk arrays

after installing hard disk drives. See the ServeRAID documentation

on the IBM ServeRAID Support CD for additional information about

RAID operation and complete instructions for using ServeRAID

Manager.

If you are installing additional hot-swap hard disk drives, do so now.

If you have other options to install or remove, do so now; otherwise go to

“Completing the installation” on page 36.

IDs for hot-swap hard disk drives

Hot-swap server models have drive bays that are connected to a SAS/SATA

backplane. This backplane, also known as the hot-swap-drive backplane, is the

printed circuit board behind these bays.

The hot-swap-drive backplane controls the IDs for the internal hot-swap drive bays.

The following table lists the IDs for the hard disk drives and backplane that are

connected to hot-swap models.

Device ID

Drive bay 4 0

Drive bay 5 1

Drive bay 6 2

Drive bay 7 3

Drive bay 8 4

Drive bay 9 5

Drive bay 10 6

Drive bay 11 7

Installing a simple-swap SATA hard disk drive (TD100 models only)

Some server models come with simple-swap SATA hard disk drives that are

accessible from the front of the server. Before you install a simple-swap SATA hard

disk drive, read the following information:

v You must turn off the server before installing simple-swap drives in the server.

v You can install only four simple-swap SATA hard disk drives in the server.

v The sequence for installing the hard disk drives is to install the drives starting

from the bottom bay (bay 7) and go up to the top bay (bay 4).

Chapter 2. Installing options 29

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 123 124

Comentarios a estos manuales

Sin comentarios

Lenovo ThinkServer TD100x Manual de usuario Pagina 45

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Lenovo ThinkServer TD100x