Lenovo ThinkServer TD100x Manual de usuario descargar pdf (Pagina 41)

c. Connect the fan power cable to the connector 1 on the system board.

12.

Install the adapters.

13. Install the left-side cover.

14. From the rear of the server, install the power supplies into the server. Push

each power supply until it stops and clicks into place.

15. Connect one end of each power cord into the connector on the back of each

power supply, and connect the other end of each power cord to a properly

grounded electrical outlet.

16. Make sure that the ac power LED on the top of each power supply is lit,

indicating that the power supply is operating correctly. If the server is turned

on, make sure that the dc power LED on the top of the power supply is lit also.

17. Reconnect the external cables.

you have other devices to install or remove, do so now. Otherwise, go to

“Completing the installation” on page 36.

Installing a drive

Depending on the server model, the server might come with an integrated drive

electronics (IDE) CD-ROM, CD-RW, or DVD/CD-RW combo drive in bay 1.

The following are illustrations of the server and the location of the drive bays. Your

hardware might differ, depending on the model.

The following is an illustration of the hot-swap server models (TD100x).

Chapter 2. Installing options 25

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 123 124

Sin comentarios

Lenovo ThinkServer TD100x Manual de usuario Pagina 41