Lenovo ThinkServer TD100x Manual de usuario descargar pdf (Pagina 46)

To install a simple-swap hard disk drive, complete the following steps:

1. Read the safety information that begins on page vii and “Installation guidelines”

on page 9.

2. Turn off the server and peripheral devices and disconnect all external cables

and power cords.

3. Unlock the side cover (you cannot open or remove the bezel without unlocking

the side cover).

4. Remove the bezel (see “Removing the bezel” on page 13.

5. Touch the static-protective package that contains the drive to any unpainted

metal surface on the server; then, remove the drive from the package and place

it on a static-protective surface.

6. Align the drive assembly with the guide rails in the bay (the connector end of

the drive goes in first).

7. Press the drive assembly loops toward each other; then, carefully slide the drive

assembly into the drive bay until it stops and release the loops.

Note: Do not release the loops on the drive assembly until it is completely

seated.

If you have other options to install or remove, do so now; otherwise, go to

“Completing the installation” on page 36.

The simple-swap-drive backplate controls the IDs for the internal simple-swap drive

bays. Always install drives into the bottom bays first, starting with ID 0.

Power and signal cables for internal drives

The server uses cables to connect parallel IDE, simple-swap SATA, hot-swap SATA

and hot-swap SAS devices to the power supply and to the system board. (See the

30 ThinkServer TD100 and TD100x Types 4203, 4204, 4205, 4206, 6398, 6399, 6419, and 6429: Installation Guide

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 123 124

Sin comentarios

Lenovo ThinkServer TD100x Manual de usuario Pagina 46